E-sky LAMA V3 Co-Axial 4CH Electric RC Helicopter (RTF)

Current Reviews: 6 | Add Your Review

Please Choose:

Controller Mode

Mode 1 (right hand throttle)

Mode 2 (left hand throttle)

socket plug

Australia socket

Europe socket

UK socket

US / Japan socket

Frequency

35 Mhz

Price :

US$79.90US$63.9020% off Report Cheaper Price

Latest Version3 Esky LAMA Co-Axial Helicopter come to Market! (NEW version EK2-0705B receiver)

V3 Lama fly stably and silently indoors and out door, just as walks in the air, enables you and your family to get warmer and enjoyment.
With double-sharing-one-axis structure and with stable and silent flight, it is designed for the beginners with simple flying operation and easy to learn how to fly. You can be familiar with its operating way and enjoy the flying in short-term.
With power supply of Li-polymer battery enable it to fly around 15 minutes.
Complete set, ready to fly. Only requires 8 AA Batteries for Transmitter.

Contra-rotating, single axis rotors cancel torque effects!	High quality transmitter with dual axis control sticks.
2 cell 7.4 volt 800 mAh Li-Poly battery pack included. Buy an extra battery pack (below) so you can fly one while charging the other!	Recharge the flight battery with the included charger that you connect to your 12 volt automobile battery.
Quality designed installation of servos, receiver, and rechargeable battery.	Easy to understand quick-reading instruction book tells exactly how helicopters fly. Shown with the included spare rotor blades.

Applicable to:
It is an entry-level helicopter. Best choice for beginners, children of 14 and over.

Rotor diameter:
Length:
Weight:
Power system:
Transmitter :
KIT/ART/RTF:
Mix controller:
Servo:
Battery:

340mm, 13.4 inch
360mm, 14.2 inch
215g
180 motor x2
4ch
RTF (ready to fly)
4 in 1 controller (W/gyro. mixer, ESC, receiver)
8g, 1.3kg/cm, 0,12s/60
7.4v 800mAh Li-polymer battery

4CH transmitter New design 4 channels helicopter (pre-built,zero assembly time). New 4 IN 1 electronic board: Receiver + Speed Controller + Mixer + Gyro. Powerful 2* main motors type 180. Two 8g mini servos One pair of crystals. 7.4V800mAh Li-Po battery AC/DC Balance Charger-AC Input:AC110v-230v. DC input:12-15v. Output: 3 pins BNC for 7.4v (2 cells) /4 pins for 11.1v (3 cells). English Manual. Extra Plastic Main Blades Flight simulator software with the cable

4CH transmitter
New design 4 channels helicopter (pre-built,zero assembly time).
New 4 IN 1 electronic board: Receiver + Speed Controller + Mixer + Gyro. Powerful 2* main motors type 180.
Two 8g mini servos
One pair of crystals.
7.4V800mAh Li-Po battery
AC/DC Balance Charger-AC Input:AC110v-230v. DC input:12-15v. Output: 3 pins BNC for 7.4v (2 cells) /4 pins for 11.1v (3 cells).
English Manual.
Extra Plastic Main Blades
Flight simulator software with the cable

Co-Co Lama ready-to-fly Micro Electric RC Helicopter

by Jerriai Malisdonia

Very easy to fly at indoor. When it goes in air and become stable, you can even release the contorl sticks but it still remains in there! It is the easiest heli that I tried. The bad thing is the rear tail is easy to break in just a little crash, Lets get some tail frame in to basket.

by Steffan Gabriele

This heli is awesome. If you want a very good beginner helicopter, just get one of these. The controls can be release and the heli stays where it is. Only problem is the the throttle doesn't seem smooth, its hard to get a hover going while keeping the same altitude due to the nature of the blades. Can take some pretty hard landings too and not damage a thing